HOW TO OPERATE YOUR
DIS~ASHER
NOTE: If dishwasher drains into a food
waste disposal, operate the disposal until
it is empty before starting dishwasher.
Step 1.
Load your dishwasher. (See Loading section,)
Step 2.
Make sure the Cycle Indicator Dial is at the
OFF position. Add detergent to the detergent
dispenser. (See Detergent Guide.) Use a rinse aid
agent to help prevent spotting. (See How to Use a
Rinse Agent section.)
Step 3.
Latch the door.
Step 4.
Select desired wash cycle.
● POTSCRUBBER—For items such as pots, pans
and casseroles with dried-on or baked-on soils.
Everyday dishes may be included. This cycle will
get heavily soiled dishes cleaner than the normal
cycle. It will not remove burned-on foods.
● NORMAL WASH—For most loads of everyday
dishes, glasses and cookware with medium soils.
Designed to yield high performance on normal soils.
Step 5.
Select the desired Energy Options.
● HEATED DRY ON—Turns the drying heater on
for fast drying. When selected, the cycle time will
be extended for 35 minutes.
● HEATED DRY OFF—Shuts off the heating unit,
thus saving energy. Dishes air-dry naturally. It takes
longer but saves energy. You can open the door after
the motor stops to speed drying. Excellent for
overnight drying.
Step 6.
Turn the Cycle Indicator Dial to START.
● Turning the dial to START will begin the cycle
immediately. To obtain the benefits of a complete
cycle, be careful that you do not turn the dial any
farther than is necessary to start the dishwasher.
There is a time delay between start-up and water
fill so you will not hear any wash action right away.
4
\
II
1
POT-
N;:~;L
HMTED
ORV
SCRUBBER
ON
OFF
II
Cycles
Enegy
Options
)
II
1
Features and appearance may
va~
sljghtly.
Dial Cycles
The SHORT WASH cycle allows you to quickly
wash loads of everyday dishes with medium
soils
that have not dried on, such as loads consisting
mostly of glasses.
a. Select The NORMAL WASH cycle and any
Energy Option if desired.
b. Be sure the door is unlatched.
c. Slowly turn the Cycle Indicator Dial to
SHORT WASH.
d. Latch the door to start the cycle.
The RINSE & HOLD cycle is for rinsing partial
loads which will be washed later. Do not
use
detergent.
a. Select HEATED DRY OFF.
b. Be sure the door is unlatched.
c. Slowly turn the Cycle Indicator Dial
to RINSE & HOLD.
d. Latch the door to start the cycle.
The PLATE WARMER cycle is for warming
clean dishes and serving plates for the serving of
hot foods. The cycle will take approximately 35
minutes if selected.
a. Load clean plates and dishes to be warmed.
b. Select HEATED DRY ON.
c. Be sure the door is unlatched.
d. Slowly turn the Cycle Indicator dial
to PLATE WARMER.
e. Latch the door to start the cycle.
To Next Page
Loading...
Need help?
General
