[11
l
/
2. Put the drawerslidesback on
the frame. ‘I’heslopedendsmust
beat the front.
3. Reachin, pushthe front ofthe
glasscoverup and, at the same
time, pull it forwarduntil it clears
the frame at the back.
4. Tilt and removethe glass cover.
3. Slidethe center and rightdrawer
slidestowardthe middleand slide
the l/3-width drawer allthe way
intothem.
5. Removethe 3 drawer slides.
6. Removethe drawer frame as
foJlows:
~ Lift the front of the frame to free
it from the supportsat each side.
~ Lift the rear of the frame to free
its hooks from the tracks on the
back wall of the refrigerator.
QTiltthe frame and take it out.
‘h replace:
1. Fit the hookson the drawer
frame into the second-from-the-
bottornslots on the tracks at the
rear of the refrigerator and lower
the front of the frame until it locks
into position and rests on the front
supports at each side.
/’-’%
—.
1
~
..-.-”
4. Slide the l/3-widthdrawerall the
wayto the right.
5. Mount the 2/3-width drawer
ontothe center and left slides.
, ~. Replace the glasscover,pushing
ltsrear edge firmly intothe rear
frame channel and gentlylowering
the front intoplace.
Toremovethe drawers,liftfrontup -------,------
slightlyand puHthe drawerstraight
out.
[
Toremovethe cover,supportit
with onehand, tilt it and takeit out. .
.. .-
J
S
A
1
~.
-
If the cover suPPortat front center,
(on models so”~quipped)becomes
separated from the drawercover,
reinstallthe supportbeforereturning
the coverto the cabinet.
,-
To ‘ffeinst.d - Wwer support,
turn the cover and support upside
down and guide the pins on the
support into the hookson the cover
as shown. Then push firmly until
the pins lock into place.
pqy)
9
-.
...
To Next Page
Loading...
