Routethe CopperTubingand ConnectIt to theShutoff Valve
Roule lhe copper robing belween lhe cold waler line and lhe refligeralor.
Roule the lubing through a hole drilled in lhe wall or floor (behind the
refligeralor or adjacent base cabinet) as close in lhe wall as possible.
Be sure thereis sufficient extra tubing[about8 feet(244 cm) coi/ed into 3 turns of about
10" (25cm) diameter] to a/low the refrigerator to move out from the waft after thsta//ation.
Place the compression nut and f&_ale (sleeve)onto the end of the tubing and
connect it lo the shuloffvalve.
Make sure the tnbing is fully inserted into the valve. Tighten the compression
nul securely.
Saddle-TypeShutoffValve
f_ _ CompressionNut
Nut I\
OutletValve Ferrule(sleeve)
TurnOnthe Water and FlushOut the Tubing
Turn lhe main waler supply on and flush oul lhe lubing until lhe waler
is clear.
Shut the water off at the water valve _ier al)oul one quar! ( 1 l) of water has
{_ been flushed through the tubing.
27
To Next Page
Loading...
