iiiHiii!iiiilJ{_iiiilliii
mmmmmmmmm_
installing the water line.
Read these instructions completely and carefully.
28
Connectthe Tubingto the Refrigerator
Before making the connection to the refrigerator, be sure the
refrigerator power cord is not plugged into the wall outlet.
We recommend installing a water filter if yam water supply has sand or particles
thai could clog tile screen of the refligerator's water valve. Install it in the water
line near the refligerator.
,_,}Remove the plastic flexible cap fiom the water valve.
Place tile compression nul and tenule (sleeve) onto the end of the tubing
as showI].
{{_ Insert tile end of the copper tubing into the water valve connection as fro as
possible X_qfileholding the tubing tighten the fitting.
Fasten the copper tubing into the clamp provided to hold it in a vertical
position. You may need to PU open the clamp.
1/4" Co eratorConnection
Turnthe Water Onat the Shutoff Valve
Tighten any connections that leak.
Plug In the Refrigerator
Arrange the coil of copper tubing so that it does not vibrate against tile back of
the refligerator or against the wall. Push the refligerator back to the wall.
Start theIcemaker
Set tile icemaker teeler ann to tile ON(do_m) position. Tile icemaker will
not begin to operate until it reaches its operating temperaune of 15°F (41°C)
or below. It xdll then begin operation automatically if the icemaker teeler arm
is in the ON (d()_I_) position.
NOTE."Theibemakermaydouble-cyclewhenit firststarts,causingsomewatersp#lagefrom
theicemakerintotheicebucket.Thisisnormalandshouldnothappenagain.
To Next Page
Loading...
