Preparingtoinstalltherefrigerator.
Read_eSe instmctio, s!comp!ete_and Carefully.
m
WaterSupplyto theIcemaker
You will need to connect the icemaker to a cold water line.
A water supply kit (containing copper tubing, shutoffvalve, fittings
and instructions) is available at extra cost from your dealer.
RefrigeratorLocation
Do not install the refrigerator where the temperature will go below
60°F. (16°C.) because it will not run often enough to maintain
proper temperatures.
Install it on a floor strong enough to support it fully loaded.
Clearances
Allow the following clearances for ease of installation, proper air
circulation and plumbing and electrical connections:
Sides 5/8" (15 mm)
Top l" (25 mm)
If built-in, allow 7/8"[22 ram] for hinge covers,
Back 1" (25 ram)
If the refrigerator is against a wall on either side, allow the following
door clearances:
For 24' models:
Refreshment center side
Freezer side
For 27' models:
Refreshment center side
Freezer side
2%" (67 mm)
3/4" (19 mm)
3V(' (89 mm)
]V(' (38 mm)
28
To Next Page
Loading...
