How to Set the
Door Alarm
Youdon’t have tos@ the visual
alarm. As long as ei~herdoor is
open, the red DOOR OPEN signal
light flashes.
If the signal light o? the
DOOR ALARM ~d is glowing,
the beeper alarm islset. If it’s not,
touch the pad to turn it on.
If either door is open for more than
30 seconds, a recurriog beep sounds.
The light goes out aod the beeping
stops when you C1OS$the door.
There are times whpn you’ll want
the Door Alarm b~per turned
off. When you’re rearranging a lot
of fd, for example. Just touch the
pad. The light will go out and the
beeping will stop.
Why the Red Warm
TemperatureLight Glows.
At first, it’sprobably because your
newly installed refrigerator hasn’t
completely cooled down yet. Wait
a fewhours for it to cool, and then
the light will go out.
From then on, the red light will
glow whenever temperatures inside
get too high for proper food storage.
If this happens, open the doors
only when absolutely necessary,
and close them as quickly as
possible.
As soon as inside temperatures
return to normal, the light goes out.
How the Electronic
Monitor and Diagnostic
System Works.
The word NORMAL is lighted
except when a failure has been
detected.
The SYSTEM CHECK-RESET
pad has two functions:
1. Youcan touch the SYSTEM
CHECK-RESET pad and get a
review of the electronic diagnostic
codes in order of their priority.
2. Youcan touch the SYSTEM
CHECK-RESET pad to erase three
flashing codes immediately and
two codes after the condition that
caused them to flash has been
corrected (see page 8).
Deactivating the Door Alarm
beeper does not turd the red DOOR
OPEN light off—it keeps flashing
until the door is closed.
(continued ne.rtpage)
To Next Page
Loading...
Need help?
General
