Electronic IWonitor& Diagnostic
The Electronic Moqitor and
Diagnostic System @ertsyou when
something starts to go wrong.
If a diagnostic cod appears on
1
the display, someth ng needs
special attention. Tb get your
attention, the display code flashes
until you erase it. The first 6
flashes are accompa~ied by beeps.
If more than one cdded function
requires attention qt the same
time, theone with tie highest
priority will be displhyed first.
Pressing the SYSTE$4 CHECK-
RESET pad will eva@ateall other
coded functions. If the NORMAL
display is lit during tbe displaying
of a code, that fhncti~n is operating
properly.
Pressing the SYSTEM CHECK-
RESET pad will erase three codes
irnmediately-.P’ Cl and CC.
The DE and FFcod@ can only be
erased by touching ~heSYSTEM
CHECK-RESET pa/dafier the
condition that causeldthe code to
flash has been corre@ed.
----
This flashing code tells you to
check your frozen find. Has any
of it started to thaw? 4 package
may be holding the fr~ezer
compartment door own. Don’t
open the door more oxen than
absolutely necessary while this
code is displayed. TouPhingthe
SYSTEM CHECK-R$SET pad
after the freezer comp@tment
temperature has retur@i to
normal will erase the @ode.
.-
System (continued)
This flashing code tells you the
This flashing code tells you
power to the refrigerator has
something’s wrong with the defrost
been interrupted for more than 2
system-keep doors closed to
seconds. Check the condition of
retain cold and call for service.
fbod in both the fresh food and
Code flashes until problem is
freezer compartments. Touch
corrected.
SYSTEM CHECK-RESET pad
to erase code.
There is no fault with the
refrigerator when PF code
flashes.
This flashing code tells you to
This flashing code tells you to
check the automatic icemaker.
check temperature controls and
Ice clumps in the storage bin may
adjust them if necessary. (See
have stalled the icemaker. Follow
directions on page 5.) Touch
corrective measures described on
SYSTEM CHECK-RESET pad
page 20. If water supply to the
to erase code. If code reappears
icemaker is not connected or not
after 4 hours, call for service.
turned on, make sure manual
icemaker switch is in the OFF
position (see page 10). Code stops
flashing when problem is corrected
or SYSTEM CHECK-RESET pad
is touched.
To Next Page
Loading...
Need help?
General
