WARNING –
POTENTIAL FIRE AND SHOCK HAZARD
• To reduce the risk of severe injury or death, follow all installation instructions.
• Clothes dryer installation must be performed by a qualified installer.
• Install the clothes dryer according to these instructions and in accordance with local codes.
• This dryer must be exhausted to the outdoors.
• Use only 4" rigid metal ducting for exhausting the clothes dryer to the outdoors.
• DO NOT install a clothes dryer with flexible plastic ducting materials. If flexible metal (semi-rigid or foil-type) duct is installed,
it must be UL-listed and installed in accordance with the instructions found in "Connecting the Dryer to House Vent" on page
7 of this manual. Flexible ducting materials are known to collapse, be easily crushed, and trap lint. These conditions will
obstruct dryer airflow and increase the risk of fire.
• Do not install or store this appliance in any location where it could be exposed to water and/or weather.
• Save these instructions. (Installers: Be sure to leave these instructions with the customer.)
• This appliance must be properly grounded and installed as described in these instructions.
Installation instructions
Spacemaker
™
for your new
Laundry
WSM2700 Electric
Before you begin – Read these instructions completely and carefully.
IMPORTANT – OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer – Be sure to leave these instructions with the Consumer.
Note to Consumer – Keep these instructions with your Owner’s Manual for future reference.
TOOLS NEEDED
IMPORTANT
• Exhausting the dryer to the outside
is required to prevent large
amounts of moisture, lint and other
products of combustion from being
blown into the room.
• Service information and a wiring
diagram are located in the dryer
access panel.
PRODUCT DIMENSIONS
75
1
⁄2″
54
5
⁄16″
3
3
⁄4″
27″
Drain outlet
(rear)
Water
inlets (rear)
Vent
9
3
⁄8″
29
7
⁄16″
41
1
⁄4″
25
1
⁄4″
16
1
⁄4″
2
1
⁄2″
47″
4
13
⁄16″
11
7
⁄16″
36
1
⁄16″
30
13
⁄16″
51°
49-90383
05-09 JR
Slip-joint pliers
Phillips-head and flat-blade screwdrivers
Ratchet with 3/8″ socket
Carpenter’s level
Adjustable wrenches
To Next Page
Need help?
General
