Why is my Gearmore Paint Sprayer's output dropping and the pump noisy?
If the output of your Gearmore Paint Sprayer drops and the pump is noisy, it's likely that the oil level is too low. To fix this, add oil until it reaches the correct level, which should be halfway up the sight tube.
Why does the pressure gauge fluctuate excessively on my Gearmore GDL200 Paint Sprayer?
If the pressure gauge on your Gearmore Paint Sprayer fluctuates excessively, it could be that the pump is sucking in air through the suction union, or air hasn't been fully removed from the pump. Check the suction hose to ensure it's firmly secured. Then, run the pump with the outlet hose open to evacuate any remaining air.
Why is oil coming out of the discharge port of my Gearmore Paint Sprayer?
If oil is coming out of the discharge port of your Gearmore Paint Sprayer, it indicates that one or more diaphragms have split. To resolve this, drain the pump of oil, dismantle the heads, and fit new diaphragms. Then, refill the pump to the correct oil level using motor oil (30W).
Why is the liquid flow irregular from my Gearmore GDL200 Paint Sprayer?
If the liquid flow from your Gearmore Paint Sprayer is irregular, it's likely that one or more valves are seating improperly. You should examine the valve seatings and clean them.
What to do if Gearmore GDL200 Paint Sprayer pumps water at little or no pressure?
If your Gearmore Paint Sprayer is pumping water at little or no pressure, the sealing washer on the pressure control valve might be worn. Replace the washer and, if necessary, the valve seat.
What to do if the Gearmore GDL200 pump does not draw water?
If the pump of your Gearmore Paint Sprayer isn't drawing water, the causes could be: * One or more valves are seating improperly. * The suction line is plugged or collapsed. * The strainer is clogged. To resolve this, examine the valve seatings and clean them. Inspect the suction line. Clean the strainer.
General| Model | GDL200 |
|---|---|
| Power Source | Electric |
| Hose Length | 50 ft |
| Type | Airless |
| Nozzle Size | 0.015 |
To Next Page