EN
33
B1279-001 © 02-2016
966.996.00.0 (00)
Cleaning and lubricating the Geberit pressing tool
1 Disconnect the mains plug.
2 Clean the roller drive, its guide and the retaining pin of the pressing tool.
3 Use a brush to remove dirt.
CAUTION! Observe the safety notes of the lubricant used.
4 Use BRUNOX®Turbo-Spray® or equivalent to lubricate the roller drive, its
guide and the retaining pin as per figure C.
5 Wipe away excess lubricant using an absorbent cloth.
WARNING
Fire risk from short circuit
` Never clean the pressing tool with water or other liquids.
To Next Page
