Maintenance
(version 7.00 and higher)
From the Settings page you can access the
Maintenance menu, which gives you access to the
following options:
• Maintenance reminders
• Standby
Use the Up and Down keys to make a selection,
and Light key to confim.
Modifying schedules
Use the arrow keys to scroll through the Water Care
selections. To see and/or modify a Water Care
category, use the lit button to the right (key 1) to
open the selected Water Care menu.
Use the arrow keys to choose a schedule to modify
(choice of economy and filtration schedules).
Use the Light key to move between parameters.
You have several possibilities for the schedule
(Mon-Fri, weekend, every day, or single days).
The schedules will be repeated every week.
The time and duration are set in 30 minute
increments. Once you have set the schedule,
use Key 1 to go back. Ensure that you have selected
the desired Water Care option in the main
Water Care menu.
If your spa uses a circulation pump configured
to run 24 hours, the screen will show you the
purge setting instead of filtration. The purges are
pre-programmed for a fixed number of minutes,
therefore the duration will be set to N/A on the
screen, and only the start time can be modified.
Settings
Settings
From the home page you can access the Settings,
where you will find:
Water care
Audio
(if installed)
Standby (version 6.00 only)
Maintenance (version 7.00 and higher)
Date & time
Keypad
Wi-Fi (Version 7.00 and higher. Only available on in.touch
with software 11.00 and higher.)
Cong*
Restore*
About
Use the arrow keys to move up and down in the list.
To select an option, press the lit button beside it
(Light button).
At any point you can press the Settings button to
return to the home screen.
*Reserved for qualified electricians installers
Water care
The Water Care section will help you set up your
ideal filtration and heating settings. Choose a mode
depending on your need.
Use the Light key to choose your setting.
A checkmark will appear on the selected icon
to confirm.
In Economy mode, the set point will be reduced
by 20°F*, which means that the heating system will
not be engaged unless the temperature falls to 20°F
below the spa's set temperature.
*Default pack value
Water care modes
Away:
In this mode the spa will always be in
economy; the set point will be reduced
by 20° F*.
Beginner:
The spa will never be in economy mode and
will be filtering according to the pack's low
level configuration.
Energy Savings:
The spa will be in economy mode during
the peak hours of the day and resume
normal mode on the weekend*.
Super Energy:
The spa will always in economy mode during
peak hours, every day of the week*.
Weekender:
The spa will be in economy mode from
Monday to Friday, and will run normally
on the weekend*.
Audio
The in.k500 can be used with either the in.tune or
in.stream audio system. The Audio section in the
Settings menu gives you the option to disconnect or
unpair your Bluetooth enabled device when using
the in.stream.
With version 7.00 and higher, it is also possible to
select Source to use a device connected by auxiliary
cable or Bluetooth wireless connection. For more
information on audio functions, see the in.tune or
in.stream operation section.
The Audio option will only appear in the menu for
keypads that are set up for an in.stream connection.
*Filtration will be reduced when the economy mode is active.
To Next Page
Loading...
Need help?
General
