Programming the purge / filter cycles
Light key
Press the Light key to turn light on. Press a second time to turn light off.
A built-in timer automatically turns light off after 2 hours, unless it has been
manually deactivated first.
The “Light” indicator lights up
when light is on.
Up/Down keys
Use Up or Down key to set desired water temperature. The temperature
setting will be displayed for 5 seconds to confirm your new selection.
The "Set Point" icon indicates that the display shows the
desired temperature, NOT the current water temperature!
Setting filter cycle duration
Press and hold the Light key until the display shows dxx, with "xx" representing
the duration in hours. (Default: 2 hours).
Use Up or Down key to change setting.
0 = no filtration 24 = continuous filtration
Note: it's not recommended to set this to "0".
Programming filter cycles
Depending on system configuration the system performs either purge cycles or filter cycles.
To program the filter cycles, you must enter these parameters: duration and frequency.
During a filter cycle, pumps & blower run at high speed for one minute to purge the
plumbing. Pump 1 or CP then runs at low speed for the remainder of the cycle.
Off Mode
(If present)
This mode allows you to stop all outputs for 30 minutes to perform a quick spa
maintenance.
Press and hold Key 1 for 5 secs to activate the Off mode. Quickly press Key 1 to
reactivate the system before the expiration of the 30-minute delay.
While the Off mode is engaged, the display will toggle between OFF and the
water temperature.
Setting the temperature display units
Quickly press the Light key again. The display will show either°F or °C.
Use Up or Down key to change units.
Press the Light key a last time to go back to normal mode.
°F = Fahrenheit °C = Celsius
OFF
To Next Page
Loading...