EasyManua.ls Logo

Gecko TRG-16 - User Manual

Gecko TRG-16
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Portable Gas Water Heater
User manual
Warning!
Please read the instructions carefully and
follow safety procedures for this product.
Ensure all users are familiar with all the
features before connecting to a gas
container. Keep this guide book for future
reference.
Attention!
Products covered by this manual will vary
in appearance, assembly, inclusions,
description and packaging.

Questions and Answers

  • F
    fvalenzuelaAug 3, 2025
    What to do if my Gecko Water Heater won't light?
    • M
      Marc JacksonAug 3, 2025
      If your Gecko Water Heater isn't lighting, first, ensure you've installed new batteries correctly, referring to the battery case for proper orientation. Next, verify you have at least 25 kPa of water pressure. Also, inspect the water inlet filter for any blockages and flush the system by reversing the water connections temporarily. Finally, check that the shower flow regulator is fully open.
  • M
    Mike FrostAug 9, 2025
    Why is my Gecko Water Heater running but not heating?
    • J
      Jonathan McintyreAug 9, 2025
      If water flows through your Gecko Water Heater but isn't getting hot, try these steps: First, replace the batteries in the ignition switch, ensuring they're correctly aligned (+-). Next, check that your water pressure is at least 25 kPa. Also, make sure the gas regulator hose is fully threaded and that your gas container has sufficient gas. Lastly, confirm that the incoming and outgoing water supplies are properly connected, with the showerhead on the water outlet and the water supply on the inlet.
  • A
    Angela StevensonAug 17, 2025
    Why does my Gecko Water Heater start then shut off?
    • C
      Cameron KingAug 17, 2025
      If your Gecko Water Heater starts briefly and then shuts off, check the following: Ensure your gas container isn't empty. If it's a new container, cycle the unit on and off using the showerhead switch to purge air from the gas lines. Also, protect the water heater from strong winds. Finally, remember that the unit needs at least 25 kPa of water pressure to stay on.
  • J
    Jennifer RobertsAug 26, 2025
    How to make my Gecko Water Heater hotter?
    • L
      lindapriceAug 26, 2025
      To increase the water temperature of your Gecko Water Heater, first, adjust the gas and water regulators. Turn the gas regulator from minimum to maximum and the water regulator from maximum to minimum. If that doesn't work, check the source water temperature; if it's too cold, cycle the water through the system back into the source reservoir and through the appliance again. Finally, check for a blue flame in the viewing window; a yellow flame may indicate a gas regulator issue, in which case you should stop using the machine and contact customer service.

Summary

Product Safety

General Safety Warnings

Crucial safety precautions and warnings for operating the appliance safely and preventing hazards.

Gas Safety Precautions

Outdoor Installation Safety

Key Safety Directives

Parts Identification

Pre-Operation Checks

Assembly Instructions

Detailed instructions on unpacking and assembling the appliance, including connections and battery installation.

Operational Guide

Post-Operation Procedures

Maintenance and Servicing

Storage and Transport

Troubleshooting Common Issues

Technical Specifications

Appendix Information

Gecko TRG-16 Specifications

General IconGeneral
BrandGecko
ModelTRG-16
CategoryWater Heater
LanguageEnglish