GeekChef VMP-12A - User Manual

Questions and Answers

L
Lorraine PerezAug 6, 2025
What to do if GeekChef VMP-12A has flare-up?
- N
  Nathan SmithAug 6, 2025
  If your GeekChef Kitchen Appliance experiences a flare-up, it could be due to several reasons: grease buildup, excessive fat in the meat, excessive temperature, or excess flour on the cooking surface. Clean the oven to remove any grease buildup. Trim fats from meat before cooking. Adjust the temperature accordingly. Ensure there isn't any excess flour on the cooking surface, and clean if necessary.
J
Jacqueline MarshallAug 11, 2025
What to do if flames blowout on GeekChef Kitchen Appliances?
- J
  Jermaine WhiteAug 11, 2025
  If the flames on your GeekChef Kitchen Appliance blowout, move the oven away from the wind. Alternatively, the propane tank may need refilling.
J
James CookAug 18, 2025
How to fix low flame or gas flow dropped suddenly in GeekChef VMP-12A?
- H
  hendersonlauraAug 18, 2025
  If you experience a low flame or sudden drop in gas flow with your GeekChef Kitchen Appliances, check your propane tank. Also, try turning off the gas control knob, wait one minute, and then light the oven. If the flame is still low, turn off both the gas control knob and the propane tank valve, then disconnect and reconnect the regulator, performing a leak test. Another solution is to turn on the propane tank valve, wait for 30 seconds, and then light the oven.
A
Anthony BrennanAug 25, 2025
How to fix GeekChef VMP-12A Kitchen Appliances false back?
- A
  Amanda LongAug 25, 2025
  A false back in your GeekChef Kitchen Appliance may be caused by blocked burner or burner tubes, or a pressure drop during ignition. Clean the burner or burner tubes. If the issue persists, turn off the pizza oven and ensure the tank valve is fully open.
S
smithlauraAug 29, 2025
How to fix burner that doesn't light on GeekChef VMP-12A?
- A
  Andrea HeathAug 29, 2025
  If the burner on your GeekChef Kitchen Appliance doesn't light, check if your propane tank is empty. Ensure the coupling nut is tightened by hand only, turning it about one half to three quarters additional turn until a solid stop. Clean the burner tube. Re-engage the burner and valve. Review the assembly instructions.