Need help?Do you have a question about the GeekTale LB-01 and is the answer not in the manual?
Guide to measure door dimensions and install the lock latch mechanism.
Steps for attaching the exterior handle to the lock mechanism.
Procedure for inserting the correct batteries into the lock.
Instructions for enrolling new fingerprints, including administrator setup.
Enabling and disabling the passage mode for continuous access.
Procedure to remove registered fingerprints, requiring administrator verification.
How to enable or disable the silent mode for quiet operation.
Method to check the remaining battery power of the lock.
Procedure to reset the lock to its factory default settings.
To Next Page
General