4
1 - CONNECTING THE TELEPHONE
- Connect the handset cord
- Open the battery door by unscrewing the retaining screw. Insert 4 x
AAA alkaline batteries. Snap the battery door in place.
In case of power failure, batteries are required for the ring.
- Connect the line cord .
- Connect the PTT plug to the wall socket.
- Connect the 12V DC adaptor cord to the telephone.
- Connect the 12V DC adaptor to your wall socket (**).
(**) Classified “hazardous voltage” according to EN60950 standard.
2 - ALARM AND RINGER OPTIONS
A 3 position switch located on the right side of the phone allows the settings
below:
-
0
: Only the ringer is activated.
-
: Ringer and shaker are activated.
-
: Ringer and strobe flash are activated.
3 - RINGER SETTINGS
A switch located on right side allows the ringer to be switched
HI,LOW,OFF:
: Off,
: Low, : Hi
Your phone comes with the ringer switched to «High» and the melody set
to «6».
SETTING UP
To Next Page
Loading...