10
OPERATING THE WIRELESS FOR HDMI UWB
Auto Switching Feature
The Auto Switching feature on the Wireless for HDMI will monitor both of the
HDMI input ports and will automatically switch when it detects that an a HDMI
source’s power has been turned on. The memory feature will automatically return
to the last viewed source when the unit detects that an HDMI source has been
turned off. To access the component source, simply turn off the power to both
of the HDMI sources and the component source will automatically be selected.
To activate this feature, press the Input Selector button on the front panel of
the sender unit until the AUTO LED becomes active. To deactivate this feature,
simply use the Input Selector button to cycle to the next input.
Manual Switching
Manual switching can be accomplished by pressing the Input Selector button
located on the front panel of the Wireless for HDMI UWB sending unit. Each
press of this button will cycle through the available inputs. The cycling function
operates in the order below:
HDMI 1 Component Video AutoHDMI 2
To Next Page
Loading...