Gehl HL 360 User Manual

Carefully inspect Hydraulic Hoses and connections
on a regular routine basis; escaping fluid
under
pressure can cause serious injury!
ALWAYS wear a hard hat when operating the Skid
Steer Loader!
Refuel in a safe place away from open flames and
potential sparks, NEVER refuel the Loader when
the engine is hot! NEVER refuel
with Loader
engine running!
The Hydrostatic Drive
of a Skid Steer Loader
operates
with Oil Flow. When the Pump is NOT
operating the Loader can move, especially if
stopped on an incline. ALWAYS PARK Loader on
level
ground with the point of the Attachment in
contact with the ground or pa rk across the incline!
DO
NOT attempt to clean, adjust, lubricate or
service the Loader when any part is moving!
DO
NOT mount or dismount the Loader with the
engine running!
DO
NOT allow minors to operate or be near the
Loader unless
properly supervised; Skid Steer
Loaders are single Seat NO passenger machines!
DO
NOT operate the Loader in a closed or confined
area; if necessary, adequate ventillation MUST be
provided!
DO
NOT leave the Loader with the Load Arms raised
unless the
Lift Cylinder Lock is positively
engaged!
DO
NOT push the LiftITiit T -Bar all the way forward
(Into "Float" position) with the Bucket or Fork
loaded and raised
as this will cause the Load Arms
to drop!
DO
NOT extend your feet beyond the front edge of
the Operator's Platform!
DO
NOT drive too close to an excavation or ditch!
BE SURE surrounding
ground has adequate
strength to
support weight of the Loader and load!
DO NOT "HOT ROD" when starting, stopping,
turning or reversing Loader directions!
DO
NOT exceed Loader rated operating capacity!
9

Gehl HL 360 Specifications

General

Brand	Gehl
Model	HL 360
Category	Front End Loaders
Language	English