10
Gerhard Geiger GmbH & Co. KG | 100W0599 0812
en
EN
EN
Gerhard Geiger GmbH & Co. KG
Schleifmühle 6
D-74321 Bietigheim-Bissingen
Telephone: +49 (0) 7142 938-0
Telefax: +49 (0) 7142 938-230
www.geiger-antriebstechnik.de
info@geiger-antriebstechnik.de
For technical questions, please call our service team at: +49 (0) 7142 938-300.
They will be happy to assist you.
12. What to do if…
Problem Solution
Motor does not run.
• Motor not plugged in.
Please check the plug connection.
• Check connecting cable for possible
damage.
• Check the mains voltage and allow
the cause of the voltage break down
to be tested by a specialist
electrician.
Instead of in the upwards direction,
motor runs downwards.
• The control leads are interchanged.
Exchange black/brown control leads.
Motor only runs in one
direction.
• Motor in the end position.
Run motor in the opposite direction.
After running several times,
the motor breaks down and
no longer responds.
• The motor became too hot and has
switched off.
Try it again after a cooling time of
about 15 min.
The blind is in the upper end posi-
tion, actuates the limit stop switch
and can no longer move downward.
• The motor has been installed upside
down or the lower end stop has been
overrun and the straps are wound up
the wrong way.
Restore free motion of the limit stop
switch.
Re-adjust the end positions
To Previous Page
Loading...
Need help?
General
