18
13.Possible faults and ways of their elimination
No.Faults Origin Elimination
1 The engine can not be started Not enough oil is filled or Check the oil level, if necessary
the gas-electric generating set is refill the engine oil or provide
situated on an inclined ground an even surface
2 The gas-electric generating set Engine oil in the combustion Remove the spark plug and
can not be started chamber (because of intensive pull through the engine with a reversing starter 3-4 times.
tilting or falling of the aggregate) Clean the carburettor and the air filter.
Mechanical damages in the range Maintenance or replacement
of the reversing starter or through a new spare part
blower hood
3 The gas-electric generating set Capacitor is defect Replace the capacitor
does not deliver enough voltage interturn short circuit in stator replace the stator by a new one
Overcurrent circuit breaker Actuate or replace the circuit
is actuated or defect breaker
Insufficient rotation speed run up to rated speed, idle
of the engine running 3180 1/min, max. 250 V
The air filter and/or the Clean the component or insert
carburettor is contaminated a new filter set
4No or not enough voltage Insufficient rotation speed of the The engine must be set to the
after loading engine or the speed controller rated speed of 3180 1/min,
is not serviceable max. 250 Volt in an authorized
workshop
Climatic influences reduce Do not load the gas-electric
the power of the gas-electric generating set generating set with the rated speed, see operating instructions of the engine
5Excessive voltage of the gas-electric Excessive speed of the engine generating set Adjust the rated speed of the engine, however max. 253 Volt
6 Generator gets inadmissible warm Overloading of the gas-electric generating set Switch off some consumers
To Next Page
Loading...
