GEL BLASTER STARFIRE - User Manual

STEP 1
STEP 2
STEP 3
STEP 6
STEP 7
STEP 4
STEP 5
- CHARGE YOUR BLASTER
- INSTALL (2) AAA BATTERIES IN YOUR ACTIVATOR
- FILL YOUR HOPPER
- PROTECT YOUR EYES!
- POWER ON AND HAVE A BLAST!
- INSTALL HOPPER ONTO BLASTER
- OPTIONAL: INTERCHANGEABLE BARRELS
Use the provided USB-C cord to charge your blaster. Do not place your charging blaster on any fabric
surface during charging. Do not leave blaster charging for an extended period of time, unplug it when
the indicator light turns green.
To install batteries, remove the Starfire Activator feedneck by pulling it towards the back of your
blaster. Once removed, locate the green door to the battery compartment. Loosen the screw in the
battery compartment cover using a Phillips screwdriver and lift. Insert two “AAA” batteries as indicated
inside the battery compartment. Follow the markings on the product for correct installation. Replace
the battery compartment cover and tighten the screw using a Phillips screwdriver.
Fill your hopper with hydrated Gellets – make sure all water is drained from the hopper before
installing on your blaster. The Gel Blaster Starfire Activator will accommodate all gellets but will only
charge Starfire Gellets for glow in the dark play.
Put on your provided eye protection when using your Gel Blaster StarFire. Make sure that others within
firing distance are wearing eye protection too! Do not shoot at people not wearing proper eye-wear.
Press the power button on the Starfire Activator. The UV light ring will power on and charge Starfire
Gellets during gameplay. Switch between Single and Full-Auto with the Blaster Mode Switch.
Screw the full hopper into the Starfire feedneck, then flip your blaster upside down to slide the
feedneck onto the top rail of the Starfire with the arrow pointing forward.
Your Gel Blaster currently comes with the Standard Barrel pre-installed (175fps). To remove the barrel,
use the Barrel Tool provided to unscrew the barrel. You can then install your orange Reduced Velocity
Barrel (100fps) for a lighter blasting experience.
IMPORTANT - Make sure you slide the feedneck all the way forward until you feel and hear a “click”.
Failing to do so will cause your Starfire to misfire.
WARNING: Don’t submerge
your Gel Blaster in water, and
make sure your Gellets are
fully strained of excess water. This will
protect the batteries and circuitry
within from failure.
IMPORTANT: DO NOT OVERTIGHTEN
+
-
STATUS LIGHTS
USB-C CHARGING PORT
BATTERY
INDICATORS
FORWARD
INDICATOR
POWER
BUTTON
UV LIGHT
RING
BATTERY
COMPARTMENT
COMPARTMENT
SCREW
CHANGE BARREL
BARREL TOOLBARREL
TO REMOVE, ROTATE
COUNTER-CLOCKWISE
BLASTER MODE SWITCH
SINGLE OFF FULL-AUTO
PULL
REMOVE FEEDNECK

Summary

Gel Blaster Starfire Operation Guide

Charge Your Blaster

Use the provided USB-C cord for charging. Avoid fabric surfaces and unplug when the indicator light turns green.

Install Activator Batteries

Remove feedneck, open battery compartment, insert two AAA batteries with correct polarity, and secure cover.

Fill and Install Hopper

Fill hopper with drained Gellets. Screw full hopper into feedneck, then slide feedneck onto blaster top rail until it clicks.

Optional: Interchangeable Barrels

Use the Barrel Tool to unscrew the standard barrel and install the Reduced Velocity Barrel for a different experience.

Safety First: Eye Protection

Wear provided eye protection. Ensure others within firing range also wear eye protection; do not shoot at unprotected individuals.

Power On and Operation

Press the power button. UV light ring activates. Switch between Single and Full-Auto modes with the Blaster Mode Switch.

Important Safety Information

General Safety Warnings

Not a toy. Adult supervision required. Wear eye protection. Do not aim at unprotected persons or animals; do not alter to resemble a firearm.

Gellet Handling Precautions

Keep Gellets away from children. Do not ingest, freeze, or eat Gellets. Always follow directions when making Gellets.

Important Battery Information

Starfire Blaster Battery

The blaster has a non-accessible, non-replaceable rechargeable battery. Examine charger for damage. Avoid misuse to prevent overheating.

Activator Battery Guidelines

Do not mix battery types or ages. Insert with correct polarity. Do not short-circuit. Remove exhausted batteries; do not recharge non-rechargeables.

Troubleshooting and Support

Hopper;Feedneck Issues

Ensure hopper faces the correct direction and is clicked securely into the feedneck to prevent misfires or feeding problems.

Gellet Feeding Problems

Gellets may not shoot correctly if not fully hydrated. Submerge Gellets in water for a minimum of 2 hours, longer for Starfire Gellets.

Warranty and Legal Agreement

Limited Warranty Details

One-month warranty against defects. Liability limited to repair/replacement. Disclaims implied warranties and limits claims to purchase price + $100.

Binding Arbitration Clause

Mandatory binding arbitration for all claims. Waives jury trial rights and class action participation. Mediation required before arbitration.

GEL BLASTER STARFIRE Specifications

General

Category	Toy
Type	Gel Blaster
Model	STARFIRE
Firing Mechanism	Electric
Firing Mode	Semi-automatic
Power Source	Battery
Material	Plastic
Recommended Age	14+
Battery	7.4V
Lighting	LED
Ammo Type	Gel pellets