R
GEM Owner’s Manual - Page 46
Operation and Maintenance
BASIC OPERATION
Basic procedure of how to operate the vehicle.
1. Turn on Main Disconnect Switch.
2. Fasten safety belts and adjust mirrors as necessary.
3. Turn key ‘On’.
4. Depress brake pedal and move direction switch to desired position.
5. Release parking brake.
6. Release brake pedal.
7. Press accelerator pedal and go.
WHAT TO DO IN EMERGENCIES
Error Code Summary and Explanation
Error codes are used in the control system to indicate conditions that prevent
the vehicle from operating. All error codes are accompanied by the
service icon. The chart shown below summarizes the most frequent error
codes and remedies.
Error Code Condition Remedy
11
Pedal is depressed when key is turned on.
Release accelerator pedal and restart car.
15 Low voltage on battery pack.
16 High voltage on battery pack.
Turn lights on for several seconds, then
turn key switch off, and back on again.
Need to charge batteries before operating.
Pedal depressed and no direction
is selected.
Release pedal and insure direction switch
is locked into a position.
06
To Next Page
Loading...
Need help?
General
