GEMAŞ Genel Mühendislik Mekanik San.ve Tic.A.Ş.
İTOB Organize Sanayi Bölgesi 10001 Sok.No:28 Menderes/İZMİR TURKEY
Tel:0232 799 0 333 Fax:0232 799 0 330 www.gemas.com.tr info@gemas.com.tr
4.2. Advices
The bipolar cells of the GSC salt chlorine generator are manufactured using a special technique, providing an
extraordinary period and resistance below the high-quality standards. However, some factors prevent you from
getting the full and longest performance from the electrode. These:
• Run with lime residue on the surface of the electrode
• Excessive chlorine concentration (over 3.00 ppm chlorine is corrosive.)
• Working with high or low pH
• Working with salt-free or high concentration salt
• Operating in water below 10 ° C
• Adding salt while the chlorinator is running
• Injecting pH regulator without placing skimmer or bottom strainer
It is recommended to periodically check the cell terminals and lubricate against sulfurization. Situations where
you need to turn off the equipment:
• Working without water
• While cleaning the filter
• When emptying the pool
• When the water freezes
• While cleaning the cell
4.3 - Fault Codes and Suggested Solutions
Cable is broken or not touching
Check cable and connection
terminals, replace if
necessary.
Check electrode cable
connection terminals.
Clean the lime from the cell
and reduce the polarity
period.
Clean the lime from the cell
and reduce the polarity
period.
Device output has a short
circuit
Check device electrode cable,
electrode connection
terminals, and replace it if
necessary.
Contact the manufacturer.
5 – WARRANTY - AFTER-SALES SERVICE - SPARE PARTS
1. The electronic cell and rectifier are under a two-year warranty.
2. The products are taken out of the scope of warranty by the following items.
a. Malfunctions caused by using the product contrary to the operating instructions.
b. Malfunctions due to incorrect electrical connections.
c. Faults caused by crash and similar accidents.
d. Malfunctions that will arise from water in its rectifier.
to. Faults resulting from operation without a bypass circuit (according to the wiring diagram).
f. Malfunctions caused by acid spillage into the skimmer without turning off the rectifier.
g. Malfunctions caused by insufficient air circulation in the engine room where the acid tank used for
disinfection is located.
h. The Puritron; It must not be in the same environment with cleaning equipment, including pumps,
filters, and multi-way valves.