Gembird 3DP-PEN-01 - User Manual

Gembird 3DP-PEN-01

9 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

• USER MANUAL • HANDBUCH • HANDLEIDING • MANUALE D'USO • ПОСІБНИК

КОРИСТУВАЧА • INSTRUKCJA OBSŁUGI • UŽIVATELSKÝ MANUÁL • MANUAL DE

USUARIO • POUŽÍVATEĽSKÁ PRÍRUČKA • ΕΓΧΕΙΡΙΔΙΟ ΧΡΗΣΤΗ

FREE FORM 3D PRINTING PEN FOR ABS/PLA

1.75MM FILAMENT

FREIE FORM 3D-DRUCKFEDER FÜR ABS / PLA

1.75MM GLÜHFADEN

3D-PEN VOOR ABS/PLA FILAMENT

PENNA PER STAMPA 3D FREE FORM PER FILAMEN-

TO ABS/PLA 1.75MM

РУЧКА ДЛЯ 3D ДРУКУ ДОВІЛЬНОЇ ФОРМИ ДЛЯ

НИТКИ ABS/PLA 1,75 ММ

DŁUGOPIS DO DRUKOWANIA 3D DO WŁÓKNA

ABS/PLA 1,75 MM

VOLNÝ FORMÁT 3D TISKAŘSKÉ PERO PRO

ABS/PLA 1,75MM FILAMENT

PLUMA DE IMPRESIÓN 3D DE FORMA LIBRE PARA

FILAMENTO ABS/PLA 1.75MM

VOĽNÁ FORMÁT 3D TLAČOVÉ PERO PRE ABS/PLA

1,75 MM FILAMENT

ΕΛΕΥΘΕΡΗ ΜΟΡΦΗ 3D ΕΚΤΥΠΩΣΗ ΜΕΝΟΣ ΓΙΑ νήμα

ABS/PLA 1,75mm

Table of Contents

Questions and Answers

M
Michael WattsAug 9, 2025
What to do if no filament comes out from Gembird 3DP-PEN-01 nozzle?
- T
  Tommy PruittAug 9, 2025
  If no filament comes out, several issues could be the cause: * The temperature might not be high enough. In this case, try replacing the nozzle set or adjusting the temperature. * There may be no working temperature. Replace the nozzle set or check the motherboard. * The gears might be slipping. Back the wire, clean the gear, and cut off any damaged supplies before reloading. * Filament may fail to load. Unload the filament and cut the end of the filament well. * The motherboard might be defective. Repair or replace it. * The heating part could be defective. Replace the nozzle set.
W
William HarrisonAug 22, 2025
How to fix Gembird 3DP-PEN-01 Accessories if the power indicator light does not flash?
- S
  Samantha KingAug 23, 2025
  If the power indicator light isn't flashing, there could be a few reasons: * The power adapter or plug line might be defective. Repair or replace the power adapter. * The motherboard could be defective. Repair or replace the motherboard. * The socket lead might be off. Solder the socket. * The nozzle might be blocked. Replace the nozzle set.

Gembird 3DP-PEN-01 Specifications

General

Category	Accessories
Product Type	3D printing pen
Material	Plastic
Diameter	1.75 mm
Nozzle Diameter	0.7 mm
Current	2A
Power Consumption	10W
Material Compatibility	PLA, ABS

Related product manuals

Gembird 3DP-PENLT-02

Preview: Gembird PB20-02

Gembird PB20-02

Preview: Gembird PB10-02

Gembird PB10-02

Preview: Gembird PB05-02

Gembird PB05-02