EasyManua.ls Logo

GEMEITA Laminator - Important Safety Instructions

GEMEITA Laminator
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Warning
1. Never leave children unattended
when the laminator is on or plugged
in.
2. Please do not put your hands on
the entrance and exit, and do not
push the laminating pouch with your
hands.
3. Be careful not to get your hair
drawn.
4. Do not disassemble or repair the
product by yourself.
5. Please place it on a flat and stable
surface.
6. Please insert and unplug the power
cord correctly, and do not use an
extension cord.
7. DO NOT use the unit in areas where
gasoline, paint, or flammable liquids
are used or stored.
8. Do not operate this machine with
wet hands.
Attention
Important safety instructions
1. Please do not laminate the paper
with much ink.
2. Be careful not to splash water on
the unit.
Only use laminating pouches of the correct size (up to A4) and thickness (80 to 125 mic).
Laminating pouches that are too thin may cause blockage inside the device.
1. This device is not intended for people (including children) with limited physical,
sensory or mental capabilities or lack of experience and knowledge, unless someone
supervises them. Responsible for your safety.
2. Please read these instructions carefully and observe them when handling your device.
3. Keep the instruction manual for future reference.
4. Do not operate the device if the power cord or plug is damaged.
5. The device is very hot during use. Do not let the heated surface touch the bare skin to
avoid burns.
6. The device can only be used in a dry, closed room.
7. Always unplug the power plug before cleaning the device. Do not use solvents or
abrasive cleaning agents.
8. Metal objects cannot be laminated.
9. Unplug the mains plug when the device is not in use.
10. Always switch off the device immediately if there is a strong smell or if the device is not
in operation.
11. Make sure that the on/off switch is in the “OFF” position before the laminator is
connected to the power supply.
12. Only insert laminating pouches intended for this purpose, as specified in the section
on performance characteristics, into the device. Laminating pouches that are too large
can cause pouch jams.
13. Do not laminate heat sensitive materials such as thermal paper.
14. Do not use laminating pouches intended for cold lamination when using hot
lamination. The machine, the laminating pouch and the document will be damaged.
15. Do not cut laminating pouches. The resulting cut edges can cause pouch jams.
When using electrical equipment, especially when children are present, you should
always follow the basic safety precautions below. To ensure the reliable operation of
the laminator, please pay attention to the following points:
EN
-02- -03-