cdmp- 7000 manual • geminidj. com
18
MIDI MODE
The CDMP-7000 has MIDI mode, which allows the data
from the buttons and dials of the CDMP-7000 to be en-
coded into MIDI format. If the unit is connected via a USB
cable to a computer with MIDI-compatible DJ software,
the DJ software can be operated from the unit. The com-
puter audio can also be played from the CDMP-7000’s
outputs.
It may not be possible to use some buttons to operate the
DJ sofware. For a list of MIDI messages refer the the MIDI
Device Messages Table.
NOTE For instructions for your specific DJ software’s
settings refer to your DJ software’s operating manual.
HID MODE
In addition to MIDI, the CDMP-7000 also uses HID protocol
which allows greater speeds.
If your software supports HID devices, disable MIDI devices
in your software, and search for HID devices. This should
locate the CDMP-7000 and allow you to use it as a HID
device.
CONFIGURING MIDI MODE
Connect the USB cable from the unit’s rear USB port (D)
to the computer. Press the MIDI source selection on the
CDMP-7000 (20). This will terminate playback of the CD/
USB/SD sources.
The CDMP-7000 will then display an audio configuration
prompt for audio bit rate and sampling rate on the touch
screen with the following audio settings:
• 24-bit/192kHz
• 24-bit/96 kHz
• 24-bit/48 kHz
• 16-bit/44.1 kHz
Press and hold the MIDI source select button to swtich be-
tween audio settings. Press MIDI to toggle between audio
settings and press the ENCODER (14) to apply the setting.
Press BACK (15) to exit.
NOTE Higher bit depth and sampling rates will create
greater latency and may impact performance.
After configuring the audio settings on the CDMP-7000,
start the DJ software:
• Select the CDMP-7000 as your MIDI device*
• Select the CDMP-7000 as your AUDIO device*
*Refer to DJ software’s instructions
midi controls
midi controls
To Next Page
Loading...
Need help?
General
