cdmp- 7000 manual • geminidj. com
23
troubleshooting
LOW/NO OUTPUT
If the CDMP-7000 is not sending a loud signal or send-
ing no signal, check for the following possible reasons:
- Input selector is set incorrectly.
- The connections are set up improperly on the back
panel.
- Bad cable(s), improperly inserted cables, or loose con-
nection.
- Jacks or plugs are dirty, making a poor contact.
DISTORTED OUTPUT
If the CDMP-7000 is sending a distorted signal, check
for the following possible reasons:
- Master output level is too high.
- Input level (gain control) is too high.
DIGITAL OUTPUT ERROR
If the CDMP-7000’s digital output is not performing,
check for the following possible reasons:
- The digital output sampling frequency of the CDMP-
7000 does not match the specifications of the con-
nected device.
- The digital output is being connected to an analog
input.
- The cable used to connect the digital output is not an
Optical S/PDIF cable.
mixer
troubleshooting
To Next Page
Loading...
