13
FIRE PROTECTION
(Applicable only where local ordinance permits use of this alarm control panel for fire protection.)
Fire-Zone Alarm
If a fire is detected, “reset FIRE ALARM” will be displayed and the keypad sounder will
pulse.
1. If a fire is in progress, evacuate the premises immediately! If necessary, call the Fire
Department from an outside phone.
2. Press the C button to silence the keypad sounder.
3. If there is no evidence of a fire, enter your User Code and press U to turn off the
alarm.
4. Check smoke detector(s). If a smoke detector tripped, its red alarm indicator light
will be on.
After the alarm condition is corrected (thermostat cooled down; smoke cleared from
detector; etc.), pressing
C again will reset the keypad within about 10 seconds.
Fire-Zone Trouble
1.
If a problem in the fire-circuit is detected, “FIRE TB” (fire trouble) will display and the
sounder will pulse to signal a malfunction.
2. Press C to silence the sounder. Call for service immediately!
reset FIRE ALARM
AC ON
FIRE/
ZONEXX
TROUBLE
AC ON
TRBL
41-XX
To Next Page
Loading...
