To Next PageTo Next Page
Need help?Do you have a question about the Gemini GX Series and is the answer not in the manual?
Read all instructions before use and avoid opening the unit.
Do not open the unit; refer servicing to qualified technicians.
Avoid direct sunlight, heat sources, rain, and moisture.
Use a damp cloth only; avoid solvents or detergents.
Use original packaging for transit to prevent damage.
Do not use spray cleaners or lubricants on controls or switches.
Connect GX-300/400 using a SpeakON cable from amplifier line out to input jack.
Connect GX-350/450 to mixers or microphones using XLR/1/4" or RCA cables.
Use auxiliary line output jacks to chain-link additional speakers.
Turn on signal source, then amplifier, adjust volume.
Turn on signal source and speaker, adjust mic/line levels, speaker level, and EQ.
Use mounting hardware to position speakers for stage monitoring.
Insert stand into the stand mounting socket and tighten.
Use rigging points for hanging or rubber feet for stacking.
Detailed technical specifications for the GX-series speakers.
Circuit diagrams for amplifier sections.
Circuit diagrams for amplifier board sections.
Circuit diagrams for amplifier sections.
Circuit diagrams for amplifier board sections.
Input/Output circuit diagram for 12-inch speakers.
Control circuit diagram for 12-inch speaker amplifier.
Power amplifier section circuit diagram for 12-inch speakers.
Crossover network schematic for SP-12UA/SP-15UA speakers.
Control circuit diagram for 15-inch speaker amplifier.
Input/Output circuit diagram for 15-inch speaker amplifier.
Power amplifier section circuit diagram for 15-inch speakers.
Crossover network schematic for SP-12UA/SP-15UA speakers.
General