Need help?Do you have a question about the Gemini MIX2GO and is the answer not in the manual?
General| Brand | Gemini |
|---|---|
| Model | MIX2GO |
| Category | Lighting Equipment |
| Language | English |
Press the power button located on the side of the MIX2GO to turn the unit on or off.
Plug the included power cable into the port below the power switch to charge the MIX2GO's battery.
Observe the power level indicator on the opposite side of the power switch and charging port.
Use the LED PANEL switch above the battery level indicator to turn on the unit's LEDs.
Press the LED MODE button on the side of the MIX2GO to cycle through different LED patterns.
Set the 'INPUT VOL' knob and 'MASTER' fader to the middle for initial streaming setup.
Press and hold the BLUETOOTH button for about 4 seconds to activate Bluetooth connectivity.
Open device Bluetooth settings, find 'Gemini MIX2GO', and connect to establish streaming.
Ensure Bluetooth is OFF, then download the 'CROSS DJ FREE' app from the App Store.
Connect your iOS device to the MIX2GO USB port using a Lightning cable.
Next, switch the MIX2GO into iOS mode using the appropriate selector.
Open the Cross DJ app; it should detect the MIX2GO, allowing you to start DJing.
Ensure Bluetooth is OFF, then download the free Mixvibes Cross DJ app on your Android device.
Connect your Android device to the MIX2GO using the included pink On-The-Go Android cable.
Next, switch the MIX2GO into Android mode using the appropriate selector.
Open the Cross DJ app; it should detect the MIX2GO, allowing you to start DJing.
To Next Page