Need help?Do you have a question about the Gemini PA-700 and is the answer not in the manual?
Describes controls like Power, Input Selection, Tape Monitor, Mic Level, Volume, Balance, EQ, Mono, Mute, Low Cut, and Loudness.
Details rear panel connections for Phono, CD, Tuner, Aux, Tape Play/Rec, Output, Ground, and Voltage Selector.
Advises on electrical shock prevention, avoiding direct sunlight, heat, moisture, and using only damp cloths for cleaning.
Explains how to use the ground lift switch to eliminate ground loops and hum for a quieter signal path.
Provides instructions for connecting turntables, CD players, tuners, tape decks, and other line-level devices.
Covers powering on the unit, selecting input sources, and adjusting volume and channel balance.
Lists input sensitivity/impedance and output impedance for various audio connections.
Details Total Harmonic Distortion, Signal to Noise Ratio, frequency response, and tone control ranges.
To Next Page
General
