To Next PageTo Next Page
Need help?Do you have a question about the Gemmy BUBBLE FOGGER 20931 and is the answer not in the manual?
Product is not a toy and requires adult supervision during use.
Ensure sufficient liquid is present before operating the device.
Place the unit on a level surface and avoid tipping it over.
Operate only in open, dry, and well-ventilated areas.
Never leave the unit unattended while it is in operation.
Always unplug the device when it is not being used.
Avoid using the device in the vicinity of pets.
Be aware that the unit becomes hot during normal operation.
Clean up any solution spills or floor accumulation promptly.
Never immerse the device in water.
Wipe the unit with a damp cloth after it has cooled down.
Do not remove the cover; there are no user-serviceable parts inside.
Always disconnect power before attempting to change the fuse.
Ensure all liquids are removed from the unit before storing.
Be aware that fog mist may activate fire alarms; use caution.
Device requires 120 volts, 60 Hz, and consumes 200 W.
Uses a 125V, 2A quick-acting fuse.
Fogger tank: 0.21 qt; Bubble tank: 0.16 qt.
The device requires approximately 2 to 5 minutes to warm up.
Connect only to properly-grounded outlets using the three-wire plug.
Ensure plug fits grounding-type AC outlets; contact electrician if needed.
Use handles to carry the hot unit to avoid contact.
Vapor may irritate sensitive individuals; avoid close range for asthmatics.
Ensure use in a well-ventilated area for safety.
Place on a stable, heat-resistant surface and keep level.
Fill fog solution and bubble juice tanks, ensuring sufficient liquid.
Plug the A/C power cord into a standard grounded wall outlet.
Turn the ON/OFF switch to 'ON'; wait for warm-up and indicator light.
Use the LARGE-STANDBY-SMALL switch for desired bubble size.
Turn off the unit, unplug, and store safely when not in use.
Replace fuse only with the same size and type to prevent fire risk.
Unplug, open cover, remove old fuse, replace with 2.0 Amps, 125 Volts fuse.
For adult use only, keep out of reach of children and pets; supervise closely.
Operate in well-ventilated areas, ensure 8" clearance around unit.
Do not expose to rain, moisture, or dust; unplug if liquid/dust enters.
Prevent cord from hanging or resting where it can be tripped over.
Use only a 3-prong, grounded electrical outlet for safe operation.
Keep at least 3 feet away from electrical devices like refrigerators, TVs.
Avoid operating without fluid to prevent damage to pump and heater.
Use with adult supervision; never drink fog or bubble solution.
Do not expose asthmatics or sensitive people to fog spray or bubbles.
Not waterproof; use outdoors only under a covered area.
Use in well-ventilated areas indoors to prevent smoke detector activation.
Be aware of potential floor residue causing slipping hazards.
Keep nozzle at least 2 feet away from people or objects during use.
Allow unit to cool before handling or servicing; do not move while operating.
Always place the unit on a flat, stable surface.
Check power source, cord connection, and fluid levels if unit is not working.
Fog solution is generally safe; minimize extended exposure and avoid asthmatics.
Do not add food coloring, scents, or other materials to the solutions.
Use recommended solutions; homemade ones may be unsafe or inefficient.
The Bubble Fogger has no user-serviceable parts; do not open.
Unit gets hot; use hanging bracket as handle, allow to cool before moving.
Periodically check fog and bubble solution levels and refill as needed.
Not recommended to blow fog/bubbles directly onto food or pets.
One quart lasts approx. 5 hours; settings affect duration.
Do not use water; it can cause permanent damage to the device.
Residual solution may be present from factory testing; does not affect operation.
Initial warm-up may show fog without bubbles; resolves after a few minutes.
Fog bubbles have a timer; fog emission without bubbles is normal between cycles.
Device complies with Part 15 of FCC Rules; subject to interference conditions.
Unauthorized modifications may void user's authority to operate the equipment.
Tips to correct harmful radio/TV interference if equipment causes it.
The Bubble Fogger is a unique device designed to produce both fog and bubbles, creating a special effect for various occasions. It is intended for indoor use and requires adult supervision during operation. The device is not a toy and should be handled with care.
The Bubble Fogger operates by heating a specialized fog solution to create fog, while simultaneously generating bubbles using a separate bubble solution. These two effects can be combined, with fog appearing inside the bubbles, or produced independently. The device features a switch to select between "SMALL" for small bubbles and "LARGE" for big bubbles, offering versatility in the visual effect. An orange indicator light illuminates when the machine is fully heated and ready for use, typically after a 2-5 minute warm-up period. The bubble wand operates on a timer, meaning there will be periods of fog emission without bubbles between activations.
To operate the Bubble Fogger, it must always be placed on a flat, stable, and heat-resistant surface, ensuring the unit remains level. Before use, the reservoir tank lid on the back of the machine should be unscrewed, and the fog solution filled into the fogger reservoir. Similarly, bubble juice needs to be filled into the bubble reservoir. It is crucial to ensure there is enough fluid in both tanks before operation to prevent damage to the pump and heater. The reservoir tank lid should be closed tightly after filling.
The device is powered by plugging its A/C power cord into a standard A/C grounded wall outlet. Once plugged in, the ON/OFF switch, located on the back of the unit, should be turned to the "ON" position. After the warm-up period, indicated by the orange light, the LARGE-STANDBY-SMALL switch can be set to the desired bubble size.
The Bubble Fogger should only be operated in open, dry, and well-ventilated areas. It is not waterproof or splash-proof, so if used outdoors, it must be under a covered area. When used indoors, good ventilation is essential to avoid setting off smoke detectors. The nozzle should be kept at least 20 inches clear of any contact while in use, and at least 2 feet away from any person or objects, as small bursts may spray out before the nozzle and create a slipping hazard. It is important not to leave the unit unattended during operation and to unplug it from the electrical outlet when not in use. The device should not be moved while in operation; allow it to cool before handling or servicing.
The fog and bubble solution should never be consumed. It is not recommended to blow fog or bubbles directly onto food or pets, as the fog spray may leave a light residue on surfaces. Vapor from the Bubble Fogger may be irritating to some individuals with allergic sensitivity, so it should not be exposed at close range to known asthmatics. Using the device in a well-ventilated area helps mitigate these concerns.
Regular maintenance is crucial for the longevity and safe operation of the Bubble Fogger. Before any service, it is imperative to disconnect power. The device does not have user-serviceable parts inside, and the cover should not be removed. Any servicing beyond basic user tasks should be referred to a qualified technician.
One key maintenance task is fuse replacement. If the device stops working, the power source may be disabled, or the cord unplugged, or the fuse may need replacement. To replace the fuse, grasp the plug and remove it from the receptacle without pulling on the cord. Open the fuse cover with a Phillips screwdriver, carefully remove the old fuse, and replace it only with a 2.0 Amps, 125 Volts quick-acting fuse of the same size and type. After replacement, close the fuse cover.
Periodically, the level of both fog and bubble solution should be checked. The manufacturer recommends filling the tank and then checking it about every hour during operation. It is critical never to operate the device without liquid in the tanks, as this can damage the pump and heater. During storage, all liquids should be removed from the device.
After use, especially if spills or residue accumulate on the floor, clean up immediately, as the solution can create a slick area and a slipping hazard. The unit itself should not be immersed in water. Instead, after it has cooled down, it can be wiped clean with a damp cloth.
It is important to note that only specialized fog solution and bubble solution designed for the Bubble Fogger should be used. Never add materials of any kind, such as oil, gas, perfume, food coloring, or homemade solutions, to the tanks. Using water or unauthorized solutions can cause permanent damage to the device and may void the warranty. While the manufacturer takes steps to remove all bubble solution after quality control tests, some residue may remain in the bubble tank at the time of purchase; this does not affect the operation of the unit.
The Bubble Fogger gets hot during normal operation. Always use the attached hanging bracket as a handle when carrying the device. Allow the unit to cool down before moving or hanging. Ensure the Bubble Fogger is placed away from combustible materials like curtains, leaves, or paper.
Finally, be aware that fog mist may activate some fire alarms, so exercise caution when operating the device in areas with smoke detectors.
General| Product Type | Bubble Fogger |
|---|---|
| Model Number | 20931 |
| Brand | Gemmy |
| Material | Plastic |
| Color | Black |
| Power Source | Electric |
