BrilliantSpa Manual 3
4. Replace the fill cap by hand tightening. Do not over-tighten.
5. Plug it in, then flip the power switch that is located on the power
cord to the “I” position to turn it on.
6. The red LED indicator shows it is heating up the water in its tank and
building up pressure. When the green LED lights up it is ready to be
used.
TO USE THE STEAMER
· The steamer may be used as soon as it has built up sufficient
pressure to light up the green LED indicator.
· Using the tweezers, hold jewelry approximately one inch beneath the
steam nozzle. Be aware that the steam is HOT.
· Then press down on the black steam activation button on the top rear
of the unit, behind the fill cap, to release the steam.
· It is recommended to use short, one or two second bursts to prolong
maximum steam pressure.
WHEN IT BECOMES NECESSARY TO REFILL
· Turn the unit off by flipping the power switch located on the power
cord to the “0” position.
· Unplug it from the power outlet.
· Allow sufficient cooling time of approximately 30 minutes prior to
refilling the tank. As a safety feature, the black fill cap can not be
removed until it has sufficiently cooled.
· While maintaining an arms length distance from the machine slowly
unscrew the black fill cap in the back. As you are unscrewing the
black fill cap the remaining pressure will release from around it. Press
down on the steam activation button in the rear of the appliance to
more quickly release the remaining steam in its tank. Remove the
black fill cap.
· Lift the entire appliance by holding the handles on either side.
· Turn the appliance upside down over a sink to drain the steamer tank.
To fully drain the steamer tank, while holding upside down, press the
steam activation button.
· Follow the instructions 1-6 on the Quick Reference Guide above to
refill the Brilliant Spa.
To Next Page
Loading...
