GeneAmp PCR System 2400

To Next Page

For Reference Only - 1 -

GeneAmp

PCR System 2400

Coolant Replacement Procedure

The GeneAmp

PCR System 2400 Thermal Cycler requires routine maintenance which

can be performed by the end user. This routine maintenance will improve the

performance of the instrument and may prevent more costly in-house repairs. The

procedure described here is for the periodic checking of the coolant in the instrument

and the procedure for re-filling the coolant, should the need arise.

Applied Biosystems service personnel can perform this procedure should you be

reluctant to do so. This service requires the instrument to be shipped to our repair

facility and the user would be charged all fees associated with this procedure. To

request a service repair of your instrument please call our Service Call Center at 1-800-

831-6844.

Applied Biosystems is not responsible for any damage to the machine, or its parts,

during the performance of this procedure.

Need help?

Do you have a question about the GeneAmp PCR System 2400 and is the answer not in the manual?

Summary

GeneAmp PCR System 2400 Coolant Replacement

Instrument Preparation

Turn off, unplug, and remove four screws from the instrument sides.

Opening the Instrument Cover

Carefully lift the instrument cover, minding the connected ribbon cable.

Locating the Coolant Reservoir

Identify the coolant reservoir in the back left-hand corner of the instrument.

Checking the Coolant Level

Unscrew the reservoir lid and check if the coolant level is full.

Filling the Coolant Reservoir

Prepare and pour a 50/50 distilled water/antifreeze mixture if coolant is low.

Cleaning the Coolant Reservoir Filter

Remove, clean with a brush and distilled water, then replace the filter.

Instrument Reassembly

Carefully replace the instrument cover, avoiding the ribbon cable, and secure screws.

GeneAmp PCR System 2400 Specifications

General

Type	Thermal Cycler
Temperature Range	4°C to 99°C
Temperature Accuracy	±0.5°C
Weight	15 lbs
Cooling Rate	Up to 1.0°C/sec
Block Formats	96-well
Display	LCD
Control Interface	Keypad and LCD display
Power Supply	100-240V, 50/60Hz
Sample Capacity	96 x 0.2 mL tubes
Ramp Rate (Cooling)	1.0°C/sec
Power	400W
Dimensions	28 x 18 x 10 inches
Power Requirements	100-240V, 50/60Hz
Temperature Uniformity	±0.5°C

GeneAmp PCR System 2400 - User Manual