Genelec F Two - Technical Specifications

Genelec Document D0164R001. Copyright Genelec Oy 5.2019. All data subject to change without prior notice
International enquiries:
Genelec, Olvitie 5
FIN-74100, Iisalmi, Finland
Phone +358 17 83881
Fax +358 17 812 267
Email genelec@genelec.com
In the U.S. please contact:
Genelec Inc., 7 Tech Circle
Natick, MA 01760, U.S.A.
Phone +1 508 652 0900
Fax +1 508 652 0909
Email genelec.usa@genelec.com
www.genelec.com
In Sweden please contact
Genelec Sverige
Ellipsvägen 10B
P.O. Box 5521, S-141 05 Huddinge
Phone +46 8 449 5220
Fax +46 8 708 7071
Email info@genelec.com
In China please contact:
Beijing Genelec Audio Co. Ltd.
Jianwai SOHO, Tower 12, Room 2605
39 East 3rd Ring Road, Chaoyang District
Beijing 100022, China
Phone +86 10 5869 7915
Fax +86 10 5869 7914
Operating Manual
F Two
AMPLIFIER SECTION
CONNECTORS
SYSTEM SPECIFICATIONS
F Two
Free eld frequency response (-6 dB) Main 27 Hz...85 Hz
LFE 27 Hz...120 Hz
Maximum short term sine wave SPL output
averaged from 30 to 85 Hz, measured in half
space at 1 meter
103 dB
Self generated noise level in half space at 1 m
on axis (A-weighted)
≤ 15 dB SPL
Driver, magnetically shielded 205 mm (8")
Weight 8.5 kg (18.7 lb)
Dimensions
Height
Diameter
300 mm (11
13
/
16
”)
362 mm (14
1
/
4
”)
F Two
Amplier short term output power
(Long term output power is limited by driver
unit protection circuitry)
150 W
Amplier system THD at nominal output ≤ 0.05 %
Mains voltage 100 - 240VAC 50/60 Hz
Power consumption (average)
Stand by
Idle
Full output
0.5 W
11 W
150 W
F Two
Analog audio inputs 10 kOhm
RCA
3.5 mm stereo jack
L, R, LFE
1
Digital audio inputs
Optical Toslink
Coaxial RCA 75 Ohm
1
1
Audio outputs
XLR balanced
RCA
L, R
L, R, LINK
Output gain 0 dB-
CROSSOVER SECTION
F Two
Subsonic lter (18 dB/octave) below 27 Hz
Crossover frequency
(subwoofer/main channels)
85 Hz
LFE channel cuto frequency 120 Hz
Midband rejection >400 Hz >50 dB
Analog input level for 90 dB SPL output at
1 m
-11 dBu at level control
max
Digital input level for 90 dB SPL output at 1 m -28 dBFS at level control
max
Digital input word length 16...24 bits
Digital input sample rate 32...96 kHz
Sensitivity adjustment range 18 dB
Level dip switches +10 dB and -10 dB
Bass Roll-O control operating range
in 2 dB steps
From 0 to -6 dB @ 27 Hz
Phase matching control in 90° steps From 0 to -270° @ 85 Hz