EasyManuals Logo

Generac Power Systems 1043-2 User Manual

Generac Power Systems 1043-2
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
Troubleshooting Points
Generac 2700PSI High Pressure Washer
GENERAC
The Reliable Ones
16
Problem Cause Correction
Pump has following problems: 1. Lance in low pressure mode. 1. Adjust chemical valve handle to
failure to produce pressure, erratic high pressure.
pressure, chattering, loss of pressure, 2. Water inlet is blocked. 2. Clear inlet.
low water volume. 3. Inadequate water supply. 3. Provide adequate water flow.
4. Garden hose is kinked or leaking. 4. Straighten garden hose, patch leak.
5. Clogged inlet hose strainer. 5. Check and clean water inlet screen.
6. Water supply is over 140°F. 6. Provide cooler water supply.
7. Outlet hose is blocked or leaks. 7. Clear blocks in outlet hose.
8. Gun leaks. 8. Replace gun.
9. Nozzle is obstructed. 9. Clear nozzle.
10. Pump is faulty. 10. Contact Generac service facility.
Detergent fails to mix with spray. 1. Chemical injector hose is not submerged. 1. Insert chemical line into deter
gent.
2. Chemical injector hose is clogged. 2. Clean or replace filter/chemical
injector hose.
3. Nozzle is in high pressure mode. 3. Push nozzle forward for low
pressure mode.
4. Chemical concentration knob is closed. 4. Open chemical concentration knob.
Engine runs well when not spraying Engine speed is too slow. Contact Generac service facility.
but bogs down when the trigger is
squeezed.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Generac Power Systems 1043-2 and is the answer not in the manual?

Generac Power Systems 1043-2 Specifications

General IconGeneral
BrandGenerac Power Systems
Model1043-2
CategoryPressure Washer
LanguageEnglish

Related product manuals