Generac Power Systems 1043-2 User Manual

Troubleshooting Points
Generac 2700PSI High Pressure Washer
GENERAC
The Reliable Ones
17
PROBLEM CAUSE CORRECTION
Engine will not start; or starts 1. Low oil level. 1. Fill crankcase to proper level.
and runs rough. 2. Dirty air cleaner. 2. Clean or replace air cleaner.
3. Out of gasoline. 3. Fill fuel tank.
4. Stale gasoline. 4. Drain gas tank; fill with fresh fuel.
5. Spark plug wire not connected 5. Connect wire to spark plug.
to spark plug.
6. Bad spark plug. 6. Replace spark plug.
7. Water in gasoline. 7. Drain gas tank; fill with fresh fuel.
8. Excessively rich fuel mixture. 8. Contact Generac service facility.
9. Intake valve stuck open or closed. 9. Contact Generac service facility.
10. Engine has lost compression. 10. Contact Generac service facility.
Engine shuts down during operation. 1. Out of gasoline. 1. Fill fuel tank.
2. Low oil level. 2. Fill crankcase to proper level.
Engine lacks power. Dirty air filter. Replace air filter.
Engine hunts or falters. Engine not operating properly. Contact Generac service facility.

Generac Power Systems 1043-2 Specifications

General

Brand	Generac Power Systems
Model	1043-2
Category	Pressure Washer
Language	English