9
Generac Portable Products 2700PSI High Pressure Washer
Similarly, attach other end of high pressure hose to
the high pressure quick connect fitting on the pump
(Figure 8). Pull on the hose to make sure it is
securely attached to the pump.
Before you connect your garden hose to the water
inlet, inspect the water inlet screen (see Figure 9).
Clean the screen if it contains debris or have it
replaced if damaged. Do not run the pressure
washer if the water inlet screen is damaged.
Connect garden hose to water inlet. Tighten firmly
by hand (Figure 9).
Turn on the water (open valve completely).
Squeeze trigger on gun to purge pump system of
air and impurities. Squeeze until a steady stream
appears.
WARNING! Before starting the pressure
washer, be sure you are wearing adequate
eye protection.
Attach dual lance to spray gun. Tighten by hand.
CHECKLIST BEFORE
STARTING ENGINE
In review, look back over the assembly to see if you
have performed all of the following.
Check for properly tightened hose connections
(high pressure and water supply). Make sure the
hoses have no kinks, cuts, or damage.
Check that oil has been added to proper level in
engine crankcase before trying to start the pressure
washer.
Add proper gasoline to fuel tank.
Provide proper water supply (not to exceed 140°F).
Be sure to read Safety Rules and Operation
sections before using the pressure washer.
Figure 8 Connect high pressure hose to pump.
Connect High
Pressure Hose
Here
Figure 9 Connect the garden hose to water inlet and
turn ON the water.
Check Screen for
Damage and
Connect Garden
Hose Here
To Next Page
Loading...
Need help?
General
