8
Generac Portable Products 2700PSI High Pressure Washer
Pour oil into the oil fill opening until it reaches point
of overflowing. DO NOT OVERFILL.
Note: The bottle of oil included with your pressure
washer contains more oil than the capacity of the
crankcase.
Install oil fill cap, hand tighten securely.
Note: Check oil often during engine breakin.
Add Gasoline
DANGER! Never fill fuel tank indoors. Never
fill fuel tank when engine is running or hot. Do
not smoke when filling fuel tank.
WARNING! Never fill fuel tank completely full.
Fill tank to about 1/2" below the bottom of the
filler neck to provide space for fuel expansion.
Wipe away any fuel spillage from engine and
equipment before starting.
Use fresh, clean fuel and store in approved
containers. Use clean fill funnels. Never use stale
gasoline left over from last season or gasoline
stored for long periods.
Clean area around gas cap. Remove cap
(Figure 6).
Add UNLEADED gasoline, slowly, to fuel tank.
Use a funnel to prevent spillage.
Install gas cap and wipe up any spilled gasoline.
Connect Hose and Water Supply to
Pump
WARNING! You must assemble wand and
attach all hoses before you start engine.
Starting engine without all hoses connected
and water supplied will damage pump.
Uncoil high pressure hose and attach hose quick
connect coupler to the fitting on the spray gun
(Figure 7). To engage the fitting, pull back on the
coupler collar, insert the gun fitting, and release the
collar. Pull on the gun to make sure it is securely in
place.
Figure 7 Connect high pressure hose to spray gun.
Figure 6 Add gasoline to fuel tank.
Gas Cap
Connect High Pressure
Hose Here
Figure 5 Add oil to engine crankcase. Do not attempt
to start engine without adding oil.
Oil Fill Cap
Make sure unit is on a level
surface before filling with oil!
Coupler Collar
To Next Page
Loading...
Need help?
General
