Generac Power Systems 2000PSI User Manual

 Insert the carriage bolt through the right hole
(looking at the front of the pressure washer) and
attach a plastic knob. Tighten the knob by hand
(Figure 2).
 Insert the carriage hook through the left hole
(looking at the front of the pressure washer). Pull
the recoil handle out slowly. Place the recoil string
through the hook and attach the plastic knob.
Tighten the knob by hand (Figure 2).
 Insert the wire form with the longer arm positioned on
the left. From this view (from rear of unit) the hook
should resemble a J
(Figure 3) .
Add Engine Oil
IMPORTANT: Any attempt to crank or start the
engine before it has been properly serviced with the
recommended oil may result in an engine failure.
Note: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF,SG, SH or SH/CD rated SAE 30
weight. Select the oils viscosity grade according to
your expected operating temperature:
Do Not Use SAE 10W40 Oil.
Although multiviscosity oils (5W30, 10W30, etc.)
improve starting in cold weather, these multiviscosity
oils will result in increased oil consumption when used
above 32°F. Check your engine oil level more
frequently to avoid possible damage from running
low on oil.
 Place pressure washer on a level surface.
 Clean area around oil fill and remove oil dipstick
(Figure 4).
 Wipe dipstick clean. Pour oil into oil fill opening until
oil reaches FULL mark on the dipstick. Stop
occasionally to check oil level. DO NOT OVERFILL.
 Install oil dipstick, hand tighten securely.
Note: Check Oil Often During Engine Breakin.
Add Gasoline
DANGER! Never fill fuel tank indoors. Never
fill fuel tank when engine is running or hot. Do
not smoke when filling fuel tank.
WARNING! Never fill fuel tank completely full.
Fill tank to about 1/2" below the bottom of the
filler neck to provide space for fuel expansion.
Wipe away any fuel spillage from engine and
equipment before starting.
Generac 2000PSI High Pressure Washer
GENERAC
The Reliable Ones
7
ASSEMBLY
Figure 3  Fit wire form on handle.
Figure 4  Add oil to engine crankcase. Do not
attempt to start engine without adding
oil.
Oil Fill Cap
Figure 2  Insert the carriage bolt and hook and
attach the knobs.
colder 32°F warmer
5W30 SAE 30

Generac Power Systems 2000PSI Specifications

General

Brand	Generac Power Systems
Model	2000PSI
Category	Pressure Washer
Language	English