Generac 2000PSI High Pressure Washer
GENERAC
The Reliable Ones
8
ASSEMBLY
The manufacturer recommends fresh, clean unleaded
automotive gasoline.
Use clean fuel and store in approved, clean,
covered containers. Use clean fill funnels. Never
use stale gasoline left over from last season or
gasoline stored for long periods.
Clean area around fuel fill cap, remove cap.
(Figure 5).
Add UNLEADED regular gasoline, slowly, to fuel
tank. Use a funnel to prevent spillage.
Install fuel cap and wipe up any spilled gasoline.
Connect Hose and Water
Supply to Pump
IMPORTANT: You must assemble wand and attach
all hoses before you start engine. Starting engine
without all hoses connected and water supplied will
damage pump.
Uncoil high pressure hose and attach one end of
hose to the base of the spray gun (Figure 6).
Tighten by hand.
Attach other end of high pressure hose to the high
pressure outlet on the pump (Figure 7). Tighten by
hand.
Before you connect your garden hose to the water
inlet, inspect the Inlet Screen (Figure 8). Clean the
screen if it contains debris or have it replaced if
damaged. Do not run the pressure washer if the
inlet screen is damaged.
Connect garden hose to water inlet. Tighten by
hand (Figure 8).
Turn ON the water (open valve completely).
Squeeze trigger on gun to purge pump system of
air and impurities.
CAUTION! Before starting the pressure
washer, be sure you are wearing adequate
eye protection.
Figure 7 Connect high pressure hose to pump.
Figure 6 Connect high pressure hose
to spray gun.
Figure 8 Connect the garden hose to water inlet
and turn ON the water.
Figure 5 Add gasoline to fuel tank.
Fuel Cap
Connect High Pressure
Hose Here
Check Screen for Damage
To Next Page
Loading...
Need help?
General
