14
High Pressure Washer
ENGINE MAINTENANCE
See the Engine Owners Manual for instructions on
how to properly maintain the engine.
SERVICE AND
ADJUSTMENTS
See the Engine Owners Manual for instructions on
how to properly service and adjust the engine
PREPARING THE UNIT FOR
STORAGE
Water should not remain in the unit for long periods of
time. Sediments of minerals can deposit on pump
parts and freeze pump action. If you do not plan to
use the pressure washer for more than 30 days,
follow this procedure:
1.Flush chemical injector hose by placing the injector
filter into a pail of clean water while running
pressure washer and squeezing the spray gun
trigger with the dual lance in low pressure mode.
Flush for two minutes.
2.Shut off the engine and let it cool, then remove all
hoses. Make sure the Run/Stop Switch is in the
STOP position.
3.Disconnect spark plug wire.
4.Empty the pump of all liquids by pulling recoil
handle about 6 times. This should remove most of
the liquid in the pump.
NOTE: To protect unit from freezing temperatures,
draw R. V. Antifreeze fluid into pump by pouring
Antifreeze fluid into a 3-foot section of garden hose
connected to inlet adapter and pulling recoil handle
twice.
5.Store in a clean, dry area.
STORING THE ENGINE
See the engine Owners manual for instructions on
how to properly store the engine.
Generac 2500PSI High Pressure Washer
To Next Page
Loading...
Need help?
General
