Home Standby Remote Start Kit Model No. G0071090
4 Instruction Sheet
14. Press the AUTO button to place the generator in the AUTO mode.
15. After completing installation, verify that the two wire start is functioning properly.
NOTE: The exercise function will need to be reset every time the 12 volt battery and T1 power to the generator are
disconnected and then reconnected, and/or when the fuse is removed and T1 power is removed from the generator.
Figure 2 - Backside of PowerPact Controller
Install wires to Terminals 3 & 7.
12345678910
11 2012 13 14 15 16 191817
J5
(Harness Back)
Part No. 10000007479 Rev. B 04/14/2017
©2017 Generac Power Systems, Inc.
All rights reserved
Specifications are subject to change without notice.
No reproduction allowed in any form without prior written
consent from Generac Power Systems, Inc.
Generac Power Systems, Inc.
S45 W29290 Hwy. 59
Waukesha, WI 53189
1-888-GENERAC (1-888-436-3722)
www.generac.com
To Previous Page
Loading...