General Foam Plastics RP2000

Questions and Answers

R
Richard CollinsAug 4, 2025
What to do if there is no flow through the return hose of my General Foam Plastics Swimming Pool Filter?
- A
  Andrew RogersAug 4, 2025
  If you're experiencing no flow or low flow through the return hose of your General Foam Plastics Swimming Pool Filter, consider the following: 1. **Water Level:** Ensure the water depth is no more than 2 inches from the bottom of the inflatable ring or covers the intake by at least 4 inches. 2. **Obstructions:** Check for any obstructions at the intake fitting and in the return hose. 3. **Filter Condition:** A dirty filter can restrict flow. Clean or replace the cartridge. Keeping spare cartridges on hand can be helpful. 4. **Rotor:** Inspect the rotor.
N
Natalie SmithAug 11, 2025
How to troubleshoot a General Foam Plastics Swimming Pool Filter motor that won't start?
- C
  Crystal JacksonAug 11, 2025
  If the motor of your General Foam Plastics Swimming Pool Filter fails to start or kicks on and off, here's what you should check: * **Power Connection:** Ensure the unit is plugged into a 3-wire grounded outlet with a GFCI type circuit breaker. * **GFCI Breaker:** Reset the circuit breaker. If the problem continues, consult an electrician to inspect the circuit. * **Voltage:** Verify the line voltage is between 105 and 125 AC volts. * **Rotor:** See the “Rotor Service” diagram in the assembly view of the Filter/Pump unit, page #5.
J
Jennifer PopeAug 18, 2025
How to fix a water leak in my General Foam Plastics Swimming Pool Filter?
- A
  Aaron ShawAug 18, 2025
  If you're experiencing water leakage with your General Foam Plastics Swimming Pool Filter, here's what to investigate: * **Hose Connections:** Adjust the hose clamp on the cuff, inspect the O-ring, and retighten. Check the hose for any holes or cracks, and replace if needed. Lubricate with petroleum jelly. * **Vent Screw:** Examine the O-ring for damage and replace if necessary. Lubricate with petroleum jelly. * **Seal Top Retainer/Seal Top:** Check the O-ring for damage and replace if needed. Lubricate with petroleum jelly. * **Pump to Volute Housing:** Tighten the screws. Inspect the Pump Gasket for damage and replace if needed. * **Volute Housing to Filter:** Check the Volute Housing O-Ring for damage and replace if needed.
M
Michael NormanOct 26, 2025
Why is my General Foam Plastics Swimming Pool Filter not cleaning the pool effectively?
- M
  Mrs. Christine EllisOct 26, 2025
  If your General Foam Plastics Swimming Pool Filter isn't cleaning the pool effectively, resulting in cloudy or green water, several factors could be at play: * **Chlorine Level:** Ensure you maintain a chlorine level between 1.0 and 1.6 ppm. * **Filter Condition:** The filter might be dirty. Clean or replace the cartridge. Keeping spare cartridges handy can make this process easier. * **pH Level:** Keep the pH level between 7.3 and 7.8. * **Cartridge Status:** Inspect the cartridge for any damage or holes, and replace it if necessary. * **Water Flow:** Check for any obstructions at the intake and return hose fittings. * **Water Quality:** It may be necessary to have your water tested at a pool supply store and add other chemicals due to varying water quality. * **Usage:** If...