XRC 200
UNIVERSAL
REMOTE
CONTROL
(Made in China)
GETTING STARTED
Congratulations! Your XRC
200 universal remote control
brings new convenience to
television viewing. By
pressing a few keys, you can
see what is on TV, select a
program to watch, set up to
record programs on your
VCR, and much more.
The XRC 200 universal
remote control has been
designed to control most TV
sets and VCRs on the market
today as well as your cable
device, eliminating the
frustration of having to use
several remote controls.
Before you start to program
your remote control, please
read the following important
instructions.
The XRC 200 enables you to:
• Control multiple devices
such as a cable
device, TV, and VCR.
• Control an auxiliary device
such as a second TV or
VCR or a digital audio
tuner.
• Control the volume
through your TV while in
Cable mode. (Refer to
Programming Volume
Control later in this
brochure.)
• Control services such as
Digital Music Express
TM and Music Choice SM.
REPLACING THE
BATTERIES
Use two fresh 1.5 volt, AA
batteries. To install or
replace the batteries:
1. Slide the battery door
open on the back of the
remote
control.
2. Remove
the old
batteries,
and insert
the new
ones as
indicated.
3. Slide the
battery
door
closed until
it snaps
into place.
4. Point the
remote
control at
your cable
device, press CABLE, and
then press POWER. The
CABLE key lights.
If the key does not light, check
the battery orientation, or
replace the batteries as
needed.
To Next Page
Need help?
General