General International 10-005 M1

Need help?

Do you have a question about the General International 10-005 M1 and is the answer not in the manual?

Summary

Main Parts and Components Identification

Key Components Overview

Diagrammatically identifies essential parts like the collector body, drum, hoses, and filters.

Setup and Assembly Preparation

Safety and Setup Requirements

Details essential safety precautions and necessary tools/assistance for unpacking and assembly.

Shop Placement Considerations

Ideal Installation Factors

Factors for determining the best installation location and space requirements for the dust collector.

Piping and Ducting Plan

Advice on planning hose and ducting layout, emphasizing safety and efficient dust collection.

Assembly Instructions

Step 1: Install Casters

Attaching the four casters to the base plate using supplied nuts and washers.

Step 2: Attach Collector Body

Securing the collector body with motor assembly to the base plate via a motor bracket.

Step 3: Mount Support Rods

Attaching vertical support rods to the base plate for structural integrity.

Step 4: Attach Drum

Securing the dust drum to the mounted support rods using hex head screws.

Final Assembly Steps

Step 5: Attach Handle

Securing the handle to the dust drum with hex head screws.

Step 6: Attach Hose

Connecting the hose to the collector body and the drum's air inlet using hose clamps.

Step 7 & 8: Install Collection Bag

Fitting the collection bag to the drum using a belt clamp for an airtight seal.

Step 9 & 10: Install Canister Filter & Gasket

Installing the canister filter and foam gasket for specific models, ensuring proper sealing.