EasyManua.ls Logo

General Sonic GS2 - Technical Specification; Information for Use as a Medical Product; Warranty

General Sonic GS2
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
6. Technical specification
Device type
GS-2
GS-3
GS-4
Tank content ml
2000
3000
4000
Power input Watt
250
420
460
Protection class
IP 20
IP 20
IP 20
Ultrasonic power HF Watt
140
160
240
Ultrasonic transducers
2
3
4
Frequency kHz
35
35
35
Heating adjustable -°C
20 80
20 - 80
20 - 80
Heating Watt
150
300
300
Timer min.
1 30
1 - 30
1 - 30
Case
stainless steel
stainless steel
stainless steel
Case measures mm
260 x 150 x 205
265 x 160 x 235
330 x 180 x 235
Tank measures mm
230 x 120 x 80
240 x 138 x 100
300 x 150 x 100
6.1 Information for use as a medical product
Denotation
UMDNS - nomenclature (ECRI)
Purpose determination
Classification
(Medical device directive
93/42/EEC, appendix IX)
Device specification
7. Warranty
The warranty duration for material defect liability on our devices is 12 months. The warranty
duration begins with the purchase or the introduction of the device (depending on which case
enters earlier). Defects are to be indicated immediately by writing statement and the device
must be put except work. In the warranty case the manufacturer reserves himself, in any case,
the right on finishing touches. An occurred exchange, whether on the whole or partially
extended not the warranty duration. For the damages on the device or cleaning objects which
are caused by improper use, use of inexpedient cleaners or chemicals no warranty exists.
Many damages are mostly to be led back on operating mistakes. Please, note:
Damages in electronics / ultrasonic generators = too long irradiation times / the longest
allowed time in one piece is 30 min..
Distortion of the cleaning objects = too high temperature
Heating defect = filling state too low, purposed with not enough liquid
Corrosion (rust) in the tank = bad, insufficient cleaning of the device, wrong cleaners,
aggressive liquid directly applied.
Damages by liquid in the electronics = tank leaking, humidity from the outside, penetrated in by
device cleaning.
© 2010 copyright by Djaky international, NL