240 ONE MAN HOLE DIGGER, FORM GOM26010601, VERSION 2.0, AUTHORIZATION: DVR, PAGE: 25
Incorrect amount of transmission lubricant. See
Service section.
C
entrifugal clutch assembly worn. Replace
A
uger diameter too large for given soil condition. See
Digging Operation section.
Incorrect throttle control/cable adjustment. See
Assembly section.
AUGER ROTATES AT IDLE SPEED
Incorrect throttle control/cable adjustment does not
permit proper engine idle speed. See Assembly
section.
Centrifugal clutch worn. Replace.
Incorrect engine idle speed. See Service section.
Storage
Proper procedure for long term storage of the Hole
Digger will protect it against the affects of corrosion
and damage. If the Hole Digger is not to be operated
for a period of 30 days or more, proceed to store as
follows:
1) Clean all accumulated dirt and grease from the Hole
Digger utilizing an approved safety solvent.
Observe all applicable safety precautions for the
solvent
2) Follow the procedure as outlined in the material
supplied by the engine manufacturer detailing long
term storage of the engine.
3) Check all visible parts for wear, breakage or
damage. Order any part required to make the
necessary repair. This will avoid a needless delay
when operating the Hole Digger at next use.
4) Apply a light coat of protective grease to the
transmission final driveshaft to prevent the formation of
rust.
5) Do not store the Hole Digger connected to an auger.
Always store the Hole Digger with the operator handle
level with the ground.
6) Store the Hole Digger inside. If the Hole Digger must
be stored outside, protect it and each auger with a
suitable covering.
Specifications
ENGINE.
TYPE Subaru Robin EH035V
HIGH SPEED 9000 RPM (No Load)
IDLE SPEED 2900 RPM
SPARK PLUG GAP .030 inch (.76 mm)
FUEL Unleaded, automotive grade
GASOLINE TANK 24 US ounces (0.75 liter)
CAPACITY
TRANSMISSION.
TYPE Enclosed, spur geared, double reduction.
REDUCTION RATIO 42.5 to 1
LUBRICANT CAPACITY 8 US ounces (224 g)
LUBRICANT SPECIFICATION High temperature
transmission grease containing an extreme pressure
(EP) additive.
CLUTCH 3 inch (76 mm) diameter, all-metal,
automatic cam type centrifugal.
AUGER CAPACITY: 2 inch (51 mm) diameter up to
and including 8 inch (203 mm) diameter. Refer to
DIGGING OPERATION for specific information.
GENERAL.
MODEL M240
REQUIRED NUMBER OF OPERATORS 1
LEAD AUGER SERIES General® 2135
TYPE/NUMBER
AUGER EXTENSION General® 2135
TYPE/SERIES NUMBER
To Next Page
Loading...