Date: 2021-08-17
Copyright of the European Union is effective (Copyright EU) (c) 2021 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
63
Configure an RCCMD-Job
RCCMD uses IP addressing to communicate within a network as well as a single network segment.
the following parameters can be adjusted:
Set up IP address for RCCMD
Broadcast messages
Activating this checkbox will trigger an RCCMD broadcast job will be sent. Each RCCMD client installed in this network segment
is addressed and responds by shutting down and turning off the computer. There is no distinction between host, virtual machine,
single server or workstation.
Limiting IP addressing
A broadcast message is not always the best method for shutting down networks...
To address a particular machine within your network, enter the IP address of the device. In fact, only addressed computer -
physically or virtual devices - will receive the RCCMD message.
The CS141 provides both:
creating a single job for each RCCMD client as well as combining several IP addresses to create a device group job.
… One job, one IP address …
… several IP-addresses to configure a group job.
To Next Page
Loading...
Need help?
General
