Generic XOR - Checking the Spark Plug; Spark Plug Warning; Checking the Air Cleaner; Air Cleaner Disassembly Procedure

CHECKING THE
SPARK
PLUG
a
Remove
the cap of high
tension cable.
(Use
a
plug
wrench in tool box to remove
the
spark
plug
turning it counterclockwise,)
a
Check the electrode if it is
dirty or fouled
by carbon
deposits.
o
Remove
the carbon
deposits on the
electrode with
steel
wire,
and clean the spark
plug
w
gasoline,
then, wipe
dry with a rag.
o
Check the electrode,
and adjust its
gap
to
O,6-0.7mm.
(Check
it with
a
feeler
gauge)
o
Hand tight
the spark
plug
as far
as
it
can
go
and
then tighten it
another
1/2-3/4
turns
with
a
wrencl
WARNING:
The
engine is very hot
after running, Pay
attention not
to
get
burned,
Use only
spark
plugs
suitable for
the engine
specifications of this motorcycle recommended by tl
manufacturer.
(Refer
to specifications.)
CHECKING THE AIR
CLEANER
DISASSEMBLE
PRCEDURE
1. Remove
the screw of air cleaner
cover.
2, Remove
the air cleaner
cover and then the.cleaner's
element.
3.
Clean or
replace
the element.
(For
checking interval
please
refer to maintenance
schedule,)
4, Refer
to
figures
shown
on the
right
for air
cleaner element
cleaning steps.
ASSEMBLE
PRCEDURT
o
Assemble
the air
cleaner
in reverse
order
of disassemble.
CAUTION;
o
Dust
deposit is
one of the major
causes of reducing
outpui
horsepower
and increasing fuel
consumption.
o
Change the
air cleaner element more frequently
to
prolong
the
engine's service life if
the motorcycle is
driven on
dusty
roads
very
often,
o
lf air
cleaner is installed improperly,
dust will
be absorbed into
cylinders, which may
cause a
premature
wear
and reducing
output
power
and
engine
life.
o
Be
careful not
to soak the air cleaner when
washinq
the
motorcycle.
Otherwise,
it
will cause engine hard
to start,
Procedures for cleaninq
cleaner element:
4_\.
i\ \
-!
l"
-
*-r
ci>
\'ir"'
t
-
\pF.-L
rF
tl
tt
2.
Squeeze
1.
CIean
{
3. Soak in engine oil.
4.
Squeez
l8